asked this on April 05, 2012 09:12
Printing with a Gen4 Arduino Mega Thingomatic, using Replicatorg 033, Firmware 3.1, and set to Skeinforge 35.
Problem is, the raft prints in such a way that it just cannot be separated from the object build.
I tried using Skeinforge 47, I know, its for the Replicator, but the raft was perfect, it easily separated.
The 47 raft printed with 2mm gaps between the base layer think lines, and then two crossed thin layers on top of each other.
The 35 raft prints with almost no gap between base layer lines, and the crossed layer is smushed into the object build.
I know 47 is for the Replicator, and the rest of the object print is not accurate, but I'm trying to get a raft change, and I can't
see how to do it with Print-o-matic.
Any help will be appreciated.
Support Software by Zendesk