I'm trying to use replicator G to update my formware to version 5.2
Replicator G can communicate with the device just fine, IE I can jog, turn leds on off etc.. from the control panel.
When I try to use the Firmwareupdate utility it does not work.
It says to hit the reset button before hitting update and I've done this over and over and over....
It keeps giving the same exact message::
The firmware update did not suceede. Check the console for details.
You can click the Upload button to try again.
Yet absolutely nothing about an upgrade attempt or failure appears in the console.
I've spent the better part of two hours trying to make this work, trying different combinations of timing in hitting the reset button and the upload, trying it with replicator G "Connected" and trying it with it not "Connected" (In all cases the replicator stays powered up and the USB stays connected, so when I say connected or not I'm referring to the connect/disconnect button at the top of the replicatorG software.
I even resorted to setting the LED's to an odd color so I could tell when the reset actually took place....
This is on a blazing fast 64bit windows 7 machine running with the latest patches etc....
Anyway to update the firmware via the SD Card?
(I've also tried this with both the SD Card installed and not installed incase reading initalizing the SD Card at the start of reset was taking time.