I am in the process of building the makerbot thingomatic but can not find the thermocouple in any of the boxes/bags/etc.  Can I get one sent to me?

I'm missing the thermocouple too. Can it be sent to me as well? Thanks.

I'm missing theAluminum Build Surface for Thing-O-Matic® Can I get one sent please?

I am also missing the thermocouple. It would be great to get one sent to me, a part number would also be useful. Regards,

I'm missing several M4 bolts and nuts and M3 nuts.  Do you need my order number?

I'm in the process of building the filament dispenser box mk1, I am missing the spindle cut out wood pieces and the turntable bearing. Can someone help me out.

help!! i just got the "Thing O Matic". i would like to find out, how many "Z Motor Flange" are we provided from the pack? i only have one "Z Motor Flange" and its attached in the end of the rod almost attaching the motor it self.  there is no space for me to squeeze a screw since it near the bottom of the rod.

or are we meant to have 2 "Z Motor Flange" in the pack??  i don't have it.

can some one tell me how many "Z Motor Flange" are we meant to have in the pack, if its only one and its attach on the rod could some one advise on this please.

thanks guys. 

Hi

just a user not a MBI staff member

kang chung

That is the normal spot for the flange it's were mine was, just turn the motor/flange till it screws off. On the z stage build instructions "*This flange might be attached to your motor so please double-check!"

as for Vahe Bandarian and others

if I remember mine was not with the extruder and was with the hardware burrito or the main electronics, it was in a small white paper (2.5" to 3.5"/6.5cm to 8.5cm) envelope looks allot like baking paper

Makerbots in the mk7 extruder build instructions say " Thermocouple(found in Gen4 electronics kit)" in the mk6+ "thermocouple included in the Extruder Controller v3.6 kit for a MakerBot Thing-O-Matic."

Jeffreypena

the aluminum build surface is an additional item that needs to be purchased in addition to the thing-o-matic.

Phibrown

does this help?  http://wiki.makerbot.com/spindle-mk1-assembly

I could be off of the marks here but this might help some of you peps or other peps viewing this later

Tim

i dont have an aluminium surface for the heated build platform in the kit. l do have a piece of plexiglass that is scored on the surface with a scored cross in the middle. Should i use this instead? How do i get the aluminium surface? Can i make one from sheet and if so what thickness of aluminium? 

I am missing the thermalcouple as well.  I searched and searched and cannot  find it anywhere.  If you need my order number I can provide.

Thanks,

The thermocouple is in a wax envelope inside the same bag that the memory card is in. Hope that helps